TM Pengaruh Dimensi Saluran Masuk pada Scrap Aluminium Sand Casting Pulley terhadap Kekerasan, Ketangguhan dan Struktur Mikro
Pengaruh Dimensi Saluran Masuk pada Scrap Aluminium Sand Casting Pulley terhadap Kekerasan, Ketangguhan dan Struktur Mikro
The purpose of this study for determine influence size of the inlet to the hardness, toughness and microstructure pulley with casting mold sand raw materials aluminum scrap. The smelting process using crucible furnace. Sand molds be made 3 kinds of different inlets, each inlet same was made 4 sand molds. Hardness testing is done by using the Vickers hardness test. the load to pressure 100 gf, the time to pressure 5 seconds. Toughness testing with use standard ASTM D256-03 machine test impact charpoy. Observation of microstructure was observed on each specimen by using an optical microscope. The hardness test results show that hardness value of the highest on the dimensions of the inlet height 6 mm is 64.4 VHN while the lowest value to the dimensions of the inlet height 5 mm is 60.96 VHN. The toughness test results show that toughness value from the three specimens almost the same is 0.057 joules / mm2; 0.0565 joule / mm2 and 0.0565 joules / mm2. While the structure micro of castings with high dimensional inlet 5 mm and 7 mm occurred structure micro which is almost the same, while the dimensions of the inlet height 6 mm has a spread of Fe, Si and Mg is more evenly distributed.
This work is licensed under a Creative Commons Attribution 4.0 International License.
Authors who publish with this journal agree to the following terms:
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).